1. Wipe the sensor window clean. Rubbing alcohol and a microfibre cloth are recommended.
2. Switch the unit off for 5 seconds, then switch the unit back on.

Lightly pull the rubber spout to wipe any dried residue.

3-4 hours or until a solid white light is displayed.

A solid white light indicates the unit is fully charged and displays when the unit is powered on. A pulsing white light indicates the unit is charging. A solid red light indicates the unit low on charge.

The air vent cutout might be clogged. Gently wipe any soap residue from around the white seal under the lid.

Pump needs to be reset:

1. Switch the unit off for 5 seconds, then attempt to switch the unit back on.
   
2. Wipe the sensor window clean. Rubbing alcohol and a microfiber cloth are recommended.
   
3. From the the powered-on position, completely cover the sensor window with your hand and toggle the power switch off, on, off, on within 2 seconds to trigger a continuous dispense mode. Stop this mode by removing your hand from the sensor window.